Cardan shaft rear transmission long wheelbase. Porsche 970.2 Panamera S RWD Executive  ›  97042103101

Cardan shaft rear transmission, RWD, Long Wheelbase
This original Porsche cardan shaft, also known as a prop shaft or rear drive shaft, transfers drive from the transmission to the rear final drive / differential, helping deliver smooth and balanced power to the rear axle.

Fits
Porsche 970.2 Panamera S 3.0L Executive 2014 - 2016 RWD
  * Engine code: CWDA, CWD, CWFA, CWF

What This Product Does

This prop shaft forms the rotating connection between gearbox output and the rear differential. Its role is to carry torque along the vehicle's driveline.

Functions

• Carries torque towards the rear differential.
• Provides the rear driveline connection for the specified Long Wheelbase RWD application.

Technical Details

• Product version: Original Porsche Product.
• Part number: 97042103101.
• Position: Rear transmission / driveline.
• Application specification: Long Wheelbase, RWD Executive.
• Diagram engine/model identifiers: CWDA,CWD,CWFA,CWF+PR:338,0E2.

Symptoms of Fault

• Speed-related vibration or judder when drive is applied.
• Clunks as the driveline takes up load.
• Rumbling from a worn shaft support.
• Joint looseness, escaping grease or visible shaft damage.

Why Replacement Matters

The cardan shaft is a rotating driveline component exposed to torque load, vibration, road conditions, heat and continuous movement. Over time, joints, support areas or balance characteristics can wear or become damaged. A worn or incorrect shaft may cause vibration, knocking, rumbling, driveline shudder or poor power transfer.

Because the Panamera 970 uses different cardan shaft versions depending on RWD / AWD and standard wheelbase / long wheelbase, it is important to replace the shaft with the correct Genuine Porsche part number for the vehicle.

FAQs

• Is this the original Porsche version?
  Yes. This product is specified as an Original Porsche Product, rather than an aftermarket replacement.
• Does vibration confirm shaft failure?
  No. Wheel, tyre and mount faults should also be considered during diagnosis.
• What should be checked before fitting?
  Verify the part reference, wheelbase, drive configuration and engine identifiers. Follow the vehicle-specific installation procedure for shaft orientation and fastener tightening.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

97042103101

The product you are viewing cross references to these numbers