Front strut brace Carbon Fibre. Porsche 992  ❭  3602109921

Rennline Rear Subframe Stabilizer With Tie Downs.

Fits:
Porsche 986 Boxster
Porsche 987 Boxster
Porsche 987 Cayman

Most Boxster and Cayman owners who take their cars to the track, have equipped their Porsches with tires much wider and stickier than stock, which allows higher g-forces to be achieved in cornering and braking. During that type of hard driving, the 2 piece rear sub frame flexes with the extreme loads being put on them. This negates your car's finely tuned alignment settings, thereby reducing your braking and cornering potential, and increasing tire wear. With this install, your Porsche will handle and brake with greater precision, predictability, and feedback to the driver. Comes with integrated rear tie down brackets and hardware for a 10 minute installation. Also available as a set including front tie downs, or as just the rear tie down set without the stabilizer bar.

Note: Pictures may not show actual product.

Rennline Strut tower brace - 2 point. FRONT.

Fits:
Porsche 997 2005>>
Porsche 987 Boxster 2005>>
Porsche 987 Cayman 2005>>

One of the easiest and most cost-effective ways to improve your car's handling is the installation of a Rennline strut tower brace. These braces bridge both shock towers, eliminating virtually all camber change that occurs during hard cornering. Not all cars are the same, so Rennline has made their braces fully adjustable, allowing you to set a desired amount of pre-stress. Both the strut bar and brackets are constructed from aircraft grade aluminum, and include stainless steel hardware. Rennline strut tower braces bolt in and out in minutes and require no drilling. Whether you're on the street or on the track you'll feel the difference immediately. This strut brace does allow the use of your plastic cowl cover but small alteration would be required.

Please note some cars might require the ends of the brace cut by approx 10mm each side in order to fit the bar on towers. This might be depending on the location of your top mounts.

Note: Pictures may not show actual product.

The RSS Harness Bars are designed to allow the use of harnesses for racing and track events. Reuses factory hardware. Made from quality materials in the USA.

Fits:
Porsche 987 Cayman 2005-12

Notes: The RSS Cayman Harness Bar is designed to allow the use of harnesses (with proper slotted racing seats) for racing and/or track events
Comes standard in a durable satin black powder coat

Note: Some minor trimming of the factory plastic will be needed in order to complete install
Installation by an experienced technician is recommended.

Images May Not be Vehicle Specific. For Display Purposes Only.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

906

The product you are viewing cross references to these numbers