Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
The OE Match Handbrake Cable is a replacement mechanical parking-brake cable for selected classic Porsche 911 SC and Carrera models from 08/1977 to 07/1989.
Length: 1413 mm
- Porsche 911 SC/Carrera 2.7-3.2 08/77-07/89
Diagram Ref No 45
Measuring approximately 1413 mm in length, the cable connects the handbrake mechanism to the rear parking-brake assembly, transmitting the driver's pull on the handbrake lever to the brake shoes at the rear wheels.
Two parking-brake cables are normally used on the vehicle, one operating each rear wheel, so replacement in pairs is often advisable where both original cables are of similar age.
What This Product Does:
The handbrake cable mechanically transfers movement from the handbrake lever to the rear parking-brake mechanism.
When the handbrake lever is pulled:
- Tension is applied to the cable
- The cable pulls the parking-brake operating mechanism
- The rear parking-brake shoes expand
- The shoes grip the internal braking surface
- The rear wheels are mechanically held
When the lever is released, the cables and brake return springs allow the parking brake to disengage.
The cable therefore provides the physical connection between the driver's handbrake lever and the rear parking brakes.
Symptoms Of Wear Or Failure:
Common symptoms of a worn or damaged handbrake cable include:
- Handbrake lever travelling unusually high
- Vehicle not holding securely when parked
- Handbrake requiring frequent adjustment
- One rear wheel holding more strongly than the other
- Parking brake dragging after release
- Handbrake lever feeling unusually stiff
- Cable movement feeling rough or notchy
- Rear brake sticking
- Grinding or scraping from the rear brake
- Excessive heat from one rear wheel
- Visible cable corrosion
- Split or damaged outer cable sheath
- Frayed inner cable
- Damaged rubber protection boots
- Cable seized inside its outer casing
A worn cable can sometimes still move but may no longer transfer the correct amount of force to the parking brake.
Why Replacement Matters:
A defective handbrake cable can compromise the vehicle's ability to remain stationary when parked.
This is particularly important when parking:
- On hills
- On uneven ground
- During servicing
- Where reliable mechanical restraint is required
Replacement restores the mechanical link between the handbrake lever and rear parking brakes.
A correctly operating cable helps provide:
- Reliable parking-brake engagement
- Proper release
- Balanced braking between rear wheels
- Predictable handbrake lever travel
- Reduced risk of brake drag
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
91142455104
The product you are viewing cross references to these numbers
- Porsche 911 1968-1973 2.2L / 2.4L / 2.7L RS LWB (F)
- Porsche 911 1974-1977 2.7L / 1976-77 3.0 Carrera
- Porsche 911 1978-1983 3.0L / SC
- Porsche 911 1984-1986 3.2L
- Porsche 911 1987-1989 3.2L G50
