Dry Carbon Fibre Ducktail Gurney Flap. Porsche 992.1 GT3 RS 2022–24  ❭  9GT827770

Silver Rocket EVO-X dry carbon fibre ducktail gurney flap for the Porsche 992.1 GT3 RS. This model-specific rear aerodynamic component follows the factory decklid profile and adds a purposeful motorsport-influenced detail.

Fits:
Porsche 992.1 GT3 RS 4.0L 2022-24

What This Product Does

The flap modifies airflow separation at the trailing edge of the decklid. Its raised profile is designed to create a controlled low-pressure region and contribute additional rear downforce while retaining the characteristic lines of the 992.1 GT3 RS.

Functions

• Manages airflow at the decklid trailing edge
• Increases the effective aerodynamic camber of the rear surface
• Supports rear-axle stability at higher speeds
• Adds a defined ducktail-style rear profile
• Integrates with the original decklid contours

Technical Details

• Silver Rocket EVO-X aerodynamic component
• Manufactured from dry carbon fibre
• High-gloss exposed carbon finish
• Carbon weave developed to coordinate with Weissach Package components
• Installed using automotive adhesive tape
• No drilling or permanent decklid modification specified by the manufacturer

Symptoms of Fault

• Lifting or movement caused by deteriorated adhesive
• Rattling or vibration around the decklid
• Cracks or damage following an impact
• Fading, lacquer wear or carbon-fibre delamination
• Uneven positioning against the decklid edge

Why Replacement Matters

A loose or damaged gurney flap may cause vibration, unwanted noise or contact with adjacent painted surfaces. Correct surface preparation and careful alignment are important for a secure, even installation. The component should be dry-fitted before its adhesive backing is applied, with the mounting area kept clean and free from wax, grease and contamination.

FAQs

• Is this gurney flap model-specific? It is shaped for the Porsche 992.1 GT3 RS factory decklid.
• Does installation require drilling? No. Silver Rocket specifies installation with automotive adhesive tape and no permanent modification.
• How should the surface be prepared? Clean and dry the decklid thoroughly, remove wax or grease and confirm alignment by dry-fitting before applying the adhesive.
• Does it match Weissach Package carbon fibre? The high-gloss weave is designed to coordinate with the exposed carbon appearance of factory Weissach Package components.
• Should a damaged flap be replaced? Replacement should be considered if the carbon is cracked, delaminated or no longer held securely against the decklid.